Toxic black mold contaminating parts of Bryan Public Library
Toxic black mold contaminating parts of Bryan Public Library
By JOHN LeBAS
Eagle Staff Writer
August 8, 2002
The black mold contaminating parts
of the Bryan Public Library is toxic,
but the growth was discovered before it became a health threat, city
officials said Wednesday.
The library remains open, although
some library employees were moved
out of their offices after mold was found on a nearby air vent. No one has
reported health problems, and an inspection team determined that the low
levels of mold didn’t warrant closing the building.
“This team had the authority
to shut us down but chose not to do so,” city
spokesman Jay Socol said.
Mold in buildings can provoke a hay
fever-like allergic reaction in sensitive
people and can cause more serious health problems for people with immune
or respiratory ailments.
The mold growth was found last week
and revealed to the Bryan City Council
on Tuesday. Most of the mold is confined the library’s basement, which
contains no books, documents or offices and is not open to the public.
An inspection was ordered after the
library reported to the city that the
air-conditioning system wasn’t cooling well. A team consisting of a doctor,
an engineer, a microbiologist and a mold-remediation consultant tested the
building for mold contamination.
Heavy mold growth was found on the
cooling coils of an air conditioning unit,
said Mark Hollas, department manager for facilities and fleet services. The
toxic stachybotyros mold was also detected in air ducts and pipe insulation.
Community Librarian Clara Mounce
had to temporarily move from her office
after black mold was found on an air vent in the room. Workers in an adjacent
office were also relocated as a precaution.
“We’ve been through a fire,
and we’ve been through other things, so we think
we can handle this,” Mounce said.
One of two library books sampled
at random was found to have mold growth.
More sampling will be done to determine if other books are contaminated,
Hollas said.
Air monitoring in the public areas
of the library showed no presence of toxic
molds, according to the consultant’s preliminary report. Culture samples
were
taken in the same locations and may show different results when they’re
ready
next week.
Hollas described the original estimate
of abatement costs — $300,000 — as
“real rough” and said the amount could change after the mold consultant
decides
how the city should proceed. Equipment and clean-up costs won’t be known
until
the consultant delivers a final plan Aug. 16.
According to a preliminary report,
much of the basement is unfinished, with a
dirt floor. The floor allows water to enter, encouraging mold growth. The high
humidity in the basement requires the immediate installation of dehumidifying
equipment, the consultant said.
Killing the mold with a fungicide
will probably take a few hours, Hollas said.
But the cleanup could take a couple of weeks.
The library was built in 1968. After
a 1995 fire, crews scraped and cleaned the
ceilings and walls throughout the building, so it’s likely the mold appeared
since then.
Cindy Kirk, Bryan’s risk management
department manager, said she was
uncertain whether the cleanup costs will be covered by insurance.
“Once we get a full report from
the remediation firm, then we’ll submit it to our
insurance carrier for review,” she said.
Bryan has been testing city facilities
for mold contamination since January,
Socol said. None has been found in buildings other than the library.